CamCtrl

Mode Channel

• The channel that is to be used for the Trigger and REC function is set under Mode Channel.
  

  The channel set here should be assigned to a triple switch on the remote control.
  The switch positions are then:

• • Switch OFF

    • Function aus

  • Switch centered

    • Function Trigger (the connected camera will trigger once)

  • Switch ON

    • Function REC ON

• Info:
  If the 3-way switch is set to the middle position, a trigger signal is output
  => a photo is taken.
  If you have assigned an additional button with an extra channel on the remote control to
  Out 1 Timing you can use it to trigger the camera further.
  Important: The triple switch then remains in the middle position.
  

---

Zoom Channel

• The channel that is to be used for the "Zoom" function is set under Zoom Channel.
  

  The channel set here should be assigned to a slider on the remote control.
  The positions are then:

• • slider centered

    • no Zoom

  • slider from the middle position to the left

    • zoom IN

  • slider from the middle position to the right

    • zoom OUT

  Info:
  

  A small adjustment from the middle position lets the camera zoom slowly,
  a large adjustment makes the camera zoom faster. To interrupt the zoom process, the potentiometer must be brought back to the middle position.

Connecting the CamCtrl I2C

GimbalCtrl

INFO:
If you use a GimbalCtrl you can set the channels for Nick and Roll under Camera => Servo control.

---

Yaw Channel

• If you use a 3-axis gimbal, the channel for yawing the gimbal can be set here under Yaw Channel.

Out1 / Out2

• The GimbalCtrl includes 2 switching outputs with different functions.
  

  Under Out1 and Out2 you can assign a free channel to use this switching outputs.
  

  More information about the switching outputs can be found here: => GimbalCtrl