DocWiki

de/MK-Parameter/Output









Switching outputs 1 + 2

http://gallery3.mikrokopter.de/var/albums/intern/MK-Baugruppen/FlightCtrl/FlightCtrl-V3.0/FC_V3_0_OUT1-2.jpg

Connections FlightCtrl V3.0
(Connections FlightCtrl V2.5)






  • +5V (max 100mA) are permanently present at the switching output. GND is switched in each case.
    If you want to switch consumers with a higher current consumption (e.g. LEDs),
    an external circuit must be used for the supply (e.g. per ExtensionPCB).


  • If you want to trigger automatically via switching output 1 during a waypoint flight,
    the WP automatic must be activated. Information about this can be found here: Link




Out 1


Out1 Bitmask

http://gallery3.mikrokopter.de/var/albums/intern/MK-Tool/Setting/Output/EN_Output-Out1.jpg



Out1 Timing





Only active after motor start

http://gallery3.mikrokopter.de/var/albums/intern/MK-Tool/Setting/Output/EN_Output-Active.jpg



combine with WP-Event







AutoTrigger every

http://gallery3.mikrokopter.de/var/albums/intern/MK-Tool/Setting/Output/EN_Output-Xmeter.jpg






Out 2


Out2 Bitmask

http://gallery3.mikrokopter.de/var/albums/intern/MK-Tool/Setting/Output/EN_Output-Out1.jpg



Out2 Timing





Only active after motor start

http://gallery3.mikrokopter.de/var/albums/intern/MK-Tool/Setting/Output/EN_Output-Active.jpg




Undervoltage

http://gallery3.mikrokopter.de/var/albums/intern/MK-Tool/Setting/Output/EN_Output-LowVolt.jpg











DocWiki: en/MK-Parameter/Output (zuletzt geändert am 06.02.2020 13:39 durch LotharF)