Info / Download

The SET-Bluetooth consists of a Bluetooth "USB" module and "Copter" module for the MikroKopter. <BR>> This can be used to establish a wireless connection between a Windows PC or a Android tablet to the MikroKopter.
(Range ~500mtr)

The Bluetooth tranmitter can be connected via USB to a Windows computer/tablet. The receiver modul will be connected to the MikroKopter.

Shoplink : SET: MK Bluetooth V2.0
FTDI-driver : Download

The connection

You can use the SET-Bluetooth with a Windows PC/Laptop/Tablet and the MikroKopter-Tool.
With this program you can configure the MikroKopter, see the telemetry of your copter and plan also a waypoint flight.

Connection at the MikroKopter

The SET-Bluetooth includes the "Copter" modul for your MikroKopter.
This receiver module will be connected via a 10 wire ribbon cable with the serial port of your FlightCtrl V3.

To do this, a 10-pin jack must be soldered to the! FlightCtrl V3.
The module can also be operated on older hardware (like e.g. FlightCtrl V2.x, NaviCtrl).

Connection at the PC

The USB cable is plugged into the Bluetooth "USB" module and the Windows PC.
The blue LED on the Bluetooth module lights up after plugging in. Now Windows should install the needed FTDI driver and the COM port for the Bluetooth module automatically.

If the automatic driver installation by Windows fails, the FTDI driver can be downloaded and manually installed here:

FTDI-driver : Download

Technical data / delivery

Delivery:

Bluetooth-Modul "USB"
Bluetooth-Modul "Copter" with 10pol socket
USB cable
Ribbon cable with 2x 10pin connector

Technical data:

Weight Bluetooth-Modul "USB" => 6g
Weight Bluetooth-Modul "Copter" => 7g
2.4GHz / 2.51mW
57600 Baud
Bluetooth PIN => 0000

Safety instructions / Intended use

To prevent short circuit, never expose this product to rain or moisture. Do not use near or near a bath, swimming pool, etc. Do not expose the components of your system to extremely high temperatures or strong light sources.
Never open the product! The device contains components which can be damaged by contact. Any manipulation of the battery can lead to serious injuries. Risk of fire! Do not heat, burn, short circuit or charge the battery with excessive or reverse polarity. The battery to be charged must stand on a non-flammable, heat-resistant and non-conductive surface during charging! Also, flammable or easily inflammable objects should be kept away from the charger. Batteries may only be charged under supervision. Incorrect treatment causes a risk of ignition, explosion, burns and burns. Suitable extinguishing media: water, CO2 , Sand. Leaking electrolyte is corrosive, do not bring into contact with skin or eyes. In case of emergency rinse immediately with plenty of water and seek medical attention.
Leave repairs or maintenance only to professionals.
In case of improper use, self-made modifications or self-made repairs, all warranty claims expire. HiSystems assumes no product liability in the event of misuse of the product or any other use of the product than its intended use. HiSystems assumes no liability for consequential damage other than statutory product liability.
Only connect the USB adapter to a power supply / PC / laptop, etc., after checking that the voltage matches the voltage specified in the technical data. Never connect a power adapter or power cord if they are damaged. In this case, contact your supplier.
This product is not a toy. Keep out of reach of children.